PISO-CAN400U-T

4-Port CAN Universal PCI board with 5-pin Screw Terminal Connectors

  • Features
  • our independent CAN bus 2.0A/2.0B communication ports
  • Compatible with CAN specification 2.0 parts A and B
  • On-board optical isolation protection
  • Programmable transfer rate up to 1 Mbps
  • 2500 Vrms photo couple isolation on the CAN bus
  • Jumper select 120Ω terminal resistor for each port
  • Direct memory mapping to the CAN controllers
  • 33MHz 32bit 5V PCI bus (V2.1) plug and play
  • Universal PCI card, supports both 5V and 3.3V PCI bus
  • We have verified to drive 100 CAN nodes at the same time

Introduction

The CAN (Controller Area Network) is a serial communication protocol, and efficiently supports distributed real-time control with a very high level of security. It is an especially suit for networking "intelligent" devices as well as sensors and actuators within a system or sub-system. In CAN networks, there is no addressing of subscribers or stations in the conventional sense, but instead prioritized messages are transmitted. As standalone CAN controller, PISO-CAN400U-T can represents an economic solution of an active CAN board. It has two or four independent CAN bus communication ports with 5-pin screw terminal connector, and has the ability to cover a wide range of CAN applications. Besides, PISO-CAN400U-T uses the new CAN controller Phillips SJA1000T and transceiver 82C250/251, which provide bus arbitration, error detection with auto correction and re-transmission function. It can be installed in a 5V PCI slot and supported truly “Plug & play”.

Applications

PISO-CAN400U-T

دانلود فایل

4-Port CAN Universal PCI board with 5-pin Screw Terminal Connectors

1400/10/26

Introduction

The CAN (Controller Area Network) is a serial communication protocol, and efficiently supports distributed real-time control with a very high level of security. It is an especially suit for networking "intelligent" devices as well as sensors and actuators within a system or sub-system. In CAN networks, there is no addressing of subscribers or stations in the conventional sense, but instead prioritized messages are transmitted. As standalone CAN controller, PISO-CAN400U-T can represents an economic solution of an active CAN board. It has two or four independent CAN bus communication ports with 5-pin screw terminal connector, and has the ability to cover a wide range of CAN applications. Besides, PISO-CAN400U-T uses the new CAN controller Phillips SJA1000T and transceiver 82C250/251, which provide bus arbitration, error detection with auto correction and re-transmission function. It can be installed in a 5V PCI slot and supported truly “Plug & play”.

Applications
دانلود فایل
برچسب ها: DeviceNet CAN J1939