MN-SERVO-DAA-EC

Distributed Motionnet Single-axis Motion Control Modules(With e-CON Mini-Clamp Connector)

  • Features
  • Maximum communication speed: 20 Mbps
  • Pulse Output Rate: 6.6 MHz (Max.)
  • Control up to 64 axes per line
  • Multi-axis linear interpolation function
  • 2-axis circular interpolation function
  • T/S-curve acceleration and deceleration
  • Change speed and position on the fly
  • Slow down sensor, home sensor, positive and negative limit sensors for each axis
  • Software limit and compare trigger output
  • Three-way isolation for power, communication and I/O.(Provide better noise immunity and device protection)
  • The EC module equipped with Mini-Clamp connector provide for an easier and debris-free wire termination process

Introduction

The MN-SERVO-EC series is used to expand the number of axes for distributed motion control on a Motionnet fieldbus. These extension slave modules can be directly connected to the servo driver and are serially connected to the controller using a simple and affordable Cat.5 LAN cable, reducing the amount of wiring required between the drivers and the controller, making this a highly suitable solution for integrated machine automation applications. After the module is connected to the servo driver, all you need to do is connect a serial LAN cable between the modules. One serial line can support up to 64 single-axis modules. ICP DAS provides a variety of motion control modules suitable for a range of brands of servo drivers, such as Mitsubishi MELSERVO-J3/J4, Yaskawa Sigma II/III/V, Panasonic MINAS A4/A5, Delta ASDA-A/A2, and Teco TSTA-A/A+.

MN-SERVO-DAA-EC

دانلود فایل

Distributed Motionnet Single-axis Motion Control Modules(With e-CON Mini-Clamp Connector)

1400/11/10

Introduction

The MN-SERVO-EC series is used to expand the number of axes for distributed motion control on a Motionnet fieldbus. These extension slave modules can be directly connected to the servo driver and are serially connected to the controller using a simple and affordable Cat.5 LAN cable, reducing the amount of wiring required between the drivers and the controller, making this a highly suitable solution for integrated machine automation applications. After the module is connected to the servo driver, all you need to do is connect a serial LAN cable between the modules. One serial line can support up to 64 single-axis modules. ICP DAS provides a variety of motion control modules suitable for a range of brands of servo drivers, such as Mitsubishi MELSERVO-J3/J4, Yaskawa Sigma II/III/V, Panasonic MINAS A4/A5, Delta ASDA-A/A2, and Teco TSTA-A/A+.
دانلود فایل